Red Series Fan + Light Switch (Z-Wave)
- 360-content|Ultimate Control:
Welcome to the Next Generation of Smart Switches.
You asked, we listened. Designed from the ground up.
Inovelli’s new Fan + Light switch is packed with features and designed with your house in mind.
For a full list, click belowView All Compatible Hubs
Alexa or Google Home?
Smart speakers are NOT Z-Wave hubs so they won't work directly with any Z-Wave devices. But you can use a compatible Z-Wave hub with smart speaker integration to control your dimmer with voice control. These include the Fibaro hubs, Hubitat, SmartThings, Vera, and Wink.
Still confused? Get in touch!
Looking for a digital copy of your instruction manual or wiring schematics? Hey, we're just glad you're reading it!
Write a Review
Easy install into wall and fan, easy setup with smart things (good instructions for adding handlers), great solution to the 'one wall switch, but fan and light' integration.
I've been waiting for over 5 years for a single gang smart fan/light dimmer combo. I preordered one to try out to make sure it worked as expected and my expectations were actually exceeded. The Hubitat driver it quite in depth and there is tons of customizations and options (almost a little overwhelming). The Z-Wave inclusion process was super straightforward. I didn't realize the LED indicators were RGB until I set everything up. I have already ordered two more units.
Installed new fan in my home office, . . . installed new switch . . . paired with Smartthings . . . working from home just got more comfy! Just ordered a second switch for daughters room.
Great product. Easy wiring and aesthetically pleasing to the eyes. The wireless fan controller piece is bigger than expected and my fan has no room for it under the cover. Luckily I have a 1 story and was able to put a 3 gang box above the fan to hold the controller. The fan speed controls acts as a dimmer rather than fan speed control for low, medium, high. Will be buying this for other ceiling fans I have. Could not join to HomeSeer (v4) securely, so far no inovelli products I have can join HomeSeer securely (Might be a HomeSeer issue). HomeSeer sees the fan as a dimmer and not a fan, again this might be a HomeSeer issue.
I use Samsung smart things and usually when I connect things to the hub it's a one and done situation with your equipment. This fan and light switch Definitely had to have the device handlers installed before it would work properly. Just a heads up. As always I love your products
Finally! I've been waiting on a fan switch for some time and was very happy to see that Inovelli had one. It's the typical Inovelli switch. It comes with great instructions, easy install, and quality service.
Replaced a GE/Jasco on/off fan switch with this and while installing the canopy unit was a PITA (expected), it works like a charm. Had to update z-wave configuration information within Home Assistant to get it to work properly, but that was also expected. It also has a very high spousal acceptance factor.
Great switch that was super easy to install, setup and pair with my Samsung Smartthings system. The only difficulty that we had was dealing with the bad fan unit mounting system. There is a slight color difference with this switch and the Red On/Off switch (this one is a little whiter than the "basic" switch).
After searching everywhere for a ceiling fan controller for ZWave, I preordered the Red Series Fan + Light Switch - and installed it as soon as I received it (July 2020). I was successfully able to integrate it with my Hubitat system, and I now have verbal control of both the fan and light through Alexa. This seems to be a common use case, where you don't have a three wire run to the ceiling fan from the wall switch, but it's impossible to find a solution, apparently. Not anymore. What's more, is the visual design of the switch is exceptional, and the functionality available to you is outstanding - If you wanted to take advantage of using the switch as a scene controller, it's available to you - with complete flexibility in how you configure it. I highly recommend using it with a capable ZWave hub like Hubitat to unlock everything available to you.