Outdoor Z-Wave Plug-In Module (1-Channel)

$39.96

Plug the Smart Outlet in. Sync. Control Your Outdoor Device from Anywhere.

Control your outdoor device with the Inovelli® Z-Wave Plus plug-in smart outlet + Z-Wave Repeater. With an IP65 rating, you can feel safe leaving your lights plugged in even in the harshest of weather (trust us, the Winters are frigid here in Michigan).

In stock (can be backordered)

SKU: FI-HNO1-FBVE Category: Tag:

Description

Simple Setup

We hand picked this Dual Channel Z-Wave Plug-in Module because it is truly, “plug and play”, can be set up in less than 5 minutes and controls multiple devices. Plug it in, sync it and you’re done.

Remote Controllable

Turn on/off lights or appliances from anywhere in the world. Once synced up, you can control two separate devices. Set schedules, or trigger an event… the power is yours!

Show Home and Inovelli Smart Plugs are Z-Wave Plus Certified

Z-Wave Plus

The 2-Channel Smart Plug is certified Z-Wave Plus, making it one of the few on the market to really take Z-Wave seriously. With a built in signal repeater, this dual smart outlet is really a cut above the competition.

Compatible HUBS


Tested Compatible HUB/Gateways

► SmartThings (HUB 1.0 & 2.0)
► Wink (HUB 1.0 & 2.0)
► Vera (UI5 & UI7)
► HomeSeer
► Leviton RF Installer Tool (Vizia)
► Staples Connect
► Zipamini (Zipato)
► Alexa/Echo**

**Only works thru a compatible HUB – Please do not buy if you do not have an external HUB

Non-compatible HUB/Gateways
► Alarm.com
► ADT Pulse
► Frontpoint
► Iris by Lowe’s
► Qolsys IQ Panel
► Vivint
► Samsung Connect*

While we’ve done our best to test as many HUB/Gateway’s as possible, please confirm that the HUB/Gateway you are pairing to supports dimming.

*This switch works with Samsung SmartThings, but not Samsung Connect — they are working on an integration between HUB’s but for now, this does not work.

Setup Instructions

Please click on the following HUB for specific setup instructions. If you do not see your HUB listed, please first check compatibility under the, “Description” tab and by scrolling down to the bottom of the page. If your HUB is compatible, but you do not see a link below, please click on, “General Z-Wave”.

SmartThings: www.inovelli.com/nzw96-setup/smartthings
Vera: www.inovelli.com/nzw96-setup/vera
Wink: www.inovelli.com/nzw96-setup/wink
General Z-Wave: www.inovelli.com/nzw96-setup/other

Additional Resources:

SmartThings Device Handlers

For the best user experience with SmartThings, a member of the SmartThings Community has created two device handlers (install both) that fully maximize the potential of this plug. Not convinced? Here are the benefits of installing the custom handlers:

  • Individual & Simultaneous Control (without installing any SmartApps)
  • Setup in literally under 2 minutes (after handlers are installed)
  • Last power state is remembered for individual switches when power is restored (NOTE: Only works on 2nd Gen firmware — devices purchased after 04/04/17)

Device Handler #1 | Device Handler #2 | Complete Setup Instructions

Reviews

There are no reviews yet.

Be the first to review “Outdoor Z-Wave Plug-In Module (1-Channel)”

Your email address will not be published. Required fields are marked *